Sinotimer Svp-916 Manual Pdf 2021 | Original

An interesting technical note in the SVP-916 Manual warns that if the under-voltage action time is set higher than 0.3 seconds , the internal microcontroller (MCU) might lose power during a drop before it can successfully trigger the relay to disconnect the circuit.

To enter the setting mode, press and hold the button for 3 seconds. Use the Up/Down arrows to adjust values. Function Description P01 Power-on Delay Time 1 – 500 seconds P02 Over-voltage Protection Value 221V – 300V – OFF P03 Over-voltage Recovery Value 220V – 299V P04 Over-voltage Protection Action Time 0.1s – 10s P05 Under-voltage Protection Value 150V – 219V – OFF P06 Under-voltage Recovery Value 151V – 220V P07 Under-voltage Protection Action Time 0.1s – 10s P08 Over-current Protection Value 1A – 63A/80A – OFF P09 Over-current Action Time 0.1s – 30s P10 Fault Recovery Delay Time 2s – 120s P11 Reset Mode AU (Auto) / HA (Manual) P12 Fault Inquiry (Last 5 records) UL (Under), UH (Over), IH (Current) P13 Finish and Exit Operational Notes Sinotimer Svp-916 Manual Pdf

To customize settings, use the physical buttons on the front panel. Follow these steps derived from the Amazon-hosted product manual: An interesting technical note in the SVP-916 Manual

Press and hold the SET button for 3 seconds. Function Description P01 Power-on Delay Time 1 –

Disclaimer: Always refer to the official Sinotimer manual for your exact hardware revision. This post is a guide, not a substitution for the manufacturer’s instructions.

| Button | Label | Function | |--------|-------|----------| | P | Program | Enter program setting mode | | + | Day/Hour | Increase value / select day | | - | Minute/Reset | Decrease value / clear setting | | Clock | Time | Set current time/day | | Manual/Auto | M/A | Toggle between ON, AUTO, OFF | | RST | Reset | Reset all settings (pin hole) |

If the previous owner left 10 old programs, you’ll see “Err” or weird behavior. of most SVP-916 manuals explains how to press the tiny R (reset) button with a paperclip. After reset, put unit in “Auto” mode.