Exergear X10 Cross Trainer Manual Better [better] Instant

: When attaching the console mast (the main column), ensure wires are tucked securely into the frame to avoid snagging or pinching during assembly.

| Problem | Stock Manual Solution | Solution | | :--- | :--- | :--- | | Clicking noise on right pedal | Tighten pedal strap | Remove pedal, apply blue Loctite to the crank bolt. The factory grease washes out in 3 months. | | Resistance fluctuates | Turn off/on | The reed switch gap is too wide. Open the lower shroud, move the reed switch closer to the magnet (credit card thickness). | | Console turns off mid-workout | Check batteries | The dynamo (self-generator) needs initial spin-up. Pedal backwards for 30 seconds to "jump start" the capacitor. | | "E-2" Error code | Replace batteries | This indicates a resistance calibration loss. Perform the reset in Part 2, then pedal at 60 RPM for 2 minutes. | Exergear X10 Cross Trainer Manual BETTER

| Frequency | Action | |-----------|--------| | After each use | Wipe down sweat from frame, pedals, console. | | Weekly | Check bolts on pedals and swing arms. Tighten if loose. | | Monthly | Apply supplied lubricant to pedal crank joints and sliding rail (if equipped). | | Every 3 months | Inspect power wires and pulse sensors. Replace batteries. | : When attaching the console mast (the main