Hw 130 Motor Control Shield For Arduino Datasheet Better Official

| Connector | Label | Description | | :--- | :--- | :--- | | J1 (Screw Term) | | Motor supply voltage (6V–12V). Do not exceed 12V for extended periods. | | J1 (Screw Term) | GND | Common ground for motors and logic. Must connect to Arduino GND. | | J2 (Screw Term) | OUT1 / OUT2 | Motor A terminals (connect one DC motor here). | | J3 (Screw Term) | OUT3 / OUT4 | Motor B terminals. | | JP2 | +5V | 5V Output from onboard regulator (or input if VS <7V). | | JP3 | ENA | Enable Channel A jumper. Short = motor enabled. Remove for PWM control. | | JP4 | ENB | Enable Channel B jumper. Remove for PWM control. | | JP1 | Power Select | Short to enable onboard 5V regulator. Open to power logic externally via +5V. |

Up to (connected to Arduino’s dedicated timers). hw 130 motor control shield for arduino datasheet

Precise speed control (the L298N has a non-linear response) or high-torque motors (get a MOSFET-based shield like the Adafruit Motor Shield v2). | Connector | Label | Description | |

delay(1000);