Why would someone choose a 24.6 MB recovery system over a full-featured live USB like Ubuntu or Hiren’s BootCD (which can be 1-2 GB)? Here are the prime scenarios:
: Once the recovery process is finished, remove the USB stick and press "REBOOT" to restart the panel with factory settings. basic2nd-recovery-system.zip -24 6 mb-
Before using the recovery file, you must prepare the hardware correctly to ensure the panel recognizes the bootable media. USB Stick: or lower version (USB 3.0 often fails to boot). The drive must be formatted to Firmware Image: Why would someone choose a 24
Find your panel's image file (typically found in your TIA Portal installation directory) and place it in the designated folder on the USB. Power Down: Completely switch off the HMI device. Insert USB: Plug the prepared drive into the panel's USB interface. Boot and Recover: Switch the power back on. The device should boot into a special recovery menu. "START RECOVERY" button three times as prompted by the interface to confirm. USB Stick: or lower version (USB 3
To use this file, users typically follow these technical requirements and steps: : Format a USB 2.0 stick (or lower) to FAT32 .
The recovery system is generally applied through one of two methods: SD Card Flash