If the test light doesn’t flash, the alarm brain is dead. If it flashes but the door doesn’t move, the actuator is faulty.
If you're replacing the alarm box or adding a new system, follow these steps for a clean install: Perodua Kenari Alarm Wiring Diagram
Battery (+) → 15A Fuse → White/Red wire → Alarm Control Unit (ACU) If the test light doesn’t flash, the alarm brain is dead
On the Perodua Kenari, the central locking module is often located behind the driver’s side kick panel (left side for right-hand drive vehicles) or under the dashboard. You need to find the wires coming out of the door conduit. You need to find the wires coming out of the door conduit
Without the correct , tracing these faults is nearly impossible.
Avoid simple "twist and tape" joins. Use soldering and heat-shrink tubing or high-quality crimp connectors to ensure the vibrations of driving don't loosen the wiring over time. Conclusion
